;- This file gives examples of load and bind statements to 
;- add to your AUTOEXEC.NCF and STARTUP.NCF files to set up 
;- Adapter Fault Tolerance on Intel EtherExpress(TM)
;- PRO/100+ TX PCI Adapters.



;- Setting up Adapter Fault Tolerance
;- ==================================


;- Copy the load statements below into the appropriate
;- files and customize them for your server. Parameters for
;- these statements are defined in your user documentation 
;- and in the AFT readme files.



;- Copy the following statement into your STARTUP.NCF file:

;- Load Adapter Fault Tolerance

load aft


;- Copy the rest of the load statments into your
;- AUTOEXEC.NCF file, and customize them for your server:


;- Load LAN driver on 1st Adapter
load e100b slot=7 frame=ethernet_802.2 name=pri_802.2
load e100b slot=7 frame=ethernet_802.3 name=pri_802.3
load e100b slot=7 frame=ethernet_snap  name=pri_snap
load e100b slot=7 frame=ethernet_ii    name=pri_ii

;- Load LAN driver on 2nd Adapter
load e100b slot=8 frame=ethernet_802.2 name=sec_802.2
load e100b slot=8 frame=ethernet_802.3 name=sec_802.3
load e100b slot=8 frame=ethernet_snap  name=sec_snap
load e100b slot=8 frame=ethernet_ii    name=sec_ii


;- Bind ipx to 1st adapter
bind ipx pri_802.2 net=2
bind ipx pri_802.3 net=3
bind ipx pri_snap net=5
bind ipx pri_ii net=11


;- Set the 2nd adapter to be an Adapter Fault Tolerance
;- partner to the first adapter
aft bind 7 8


;- Note: No protocols should be bound to the secondary
;- adapter. All protocol bindings to the primary adapter
;- will be transferred to the secondary if the primary link
;- fails.



;- *********************************************************

                                                    ;- v1.01